i try to install the router to my internet modem, after i did correctly, it keeps saying "No Connectivity"
I installed a Dyntex wireless router to my comcast modem, by using ethernet cable. I followed all the instructions from the CD-rom, but it still tells me i have no connectivity. But all the lights on the router were lit and everything.
Tagged with: cd rom • comcast • connectivity • modem • router
Filed under: How To Install a modem
With everthing connected, press and release the reset button on your router. It should auto configure and begin working, chances are that your comcast modem and your ROUTER have DHCP enabled which means they are both trying to automatically assign ip addresses to each other and your PC which won’t work…. If the reset button doesn’t work. Disable DHCP in your router interface and restart your computer.
I don’t know about Dyntex but technically, if you’re wired to your wireless router, then yes, it should work. You were connected BEFORE your router was hooked up, right? Is your wireless card in your computer disabled? Have you tried another ethernet cable. I’ve never had to have a disk to setup my router, but then again, I have a Linksys Router too. Sometimes you need to type in the routers homepage and change settings there too, but again, not if you are connected to the router….it should automatically connect to you. Try looking at their homepage or calling Dyntex’s tech support. if they have good support, they WILL see that you get connected….wirelessly.
.